feedwater injector

The injector was originally used in the boilers of steam locomotives for injecting or pumping the boiler feedwater into the boiler. The injector consisted of a body containing a series of three or more nozzles, "cones" or "tubes". The motive steam passed through a nozzle that reduced its pressure below atmospheric and increased the steam velocity. Fresh water was entrained by the steam jet, and both steam and water entered a convergent "combining cone" which mixed them thoroughly so that the water condensed the steam. The condensate mixture then entered a divergent "delivery cone" which slowed down the jet, and thus built up the pressure to above that of the boiler. An overflow was required for excess steam or water to discharge, especially during starting. There was at least one check valve between the exit of the injector and the boiler to prevent back flow, and usually a valve to prevent air being sucked in at the overflow.
After some initial skepticism resulting from the unfamiliar and superficially paradoxical mode of operation, the injector was widely adopted as an alternative to mechanical pumps in steam-driven locomotives. The injectors were simple and reliable, and they were thermally efficient.
Efficiency was further improved by the development of a multi-stage injector which was powered not by live steam from the boiler but by exhaust steam from the cylinders, thereby making use of the residual energy in the exhaust steam which would otherwise have gone to waste.